Origami on Halloween: How to make them from paper A4 stages? Scary ghosts and spiders, light schemes for creating pumpkins for beginners, Other crafts

Our today's material is devoted to the creation of origami on Halloween. The master classes on the manufacture of pumpkin from A4 paper, terrible ghosts and spiders are considered.

How to make a pumpkin?

It is this fetter that is most often associated with this holiday, has become actually its symbol. If there is no possibility to buy a ready pumpkin or bother with similar berries, then quite a good option - Production of pumpkin origami on Halloween from paper A4. The composition for the garland is best to do from special paper "Kami". The technique is very simple and suitable even for children who have no origami experience. One fruit can be created from the square 150x150 mm; A little more yellow paper will be needed for a characteristic tail.

Sequence of work:

Deploy colored paper inside out;
combine the top and bottom of the sheet;
smoothed the triangles created in this way;
impose a right angle on the left and smoothed the line that appeared now;
reveal pockets on the left;
pressed it and flattened;
do the same with the pocket on the right;
Perform the bends on the dotted line, diligently hiding the corners and protrusions inside the figure;
fold the future pumpkin at the top;
rejuvenate the top a little back;
Figure the figure below;
remove all protrusions and heterogeneities so that it is really a round pumpkin;
Dorify a sinister smile corresponding to the stylistry of the festival;
Under the top valve ropted;
Fasten the origami received (it is better to do a few pieces) on the garland and decorate with them one of the walls of the room.

Desktop pumpkin "Jack" It can also be imitated in the spirit of origami. Based paper sheet 150x150 mm. Ideally, his facial side is orange or yellow, and the turnover - pure white; If there is only white paper in the house, paint will come to the revenue. One of the vertices of the square turn over. Making a fold diagonally, disclose the resulting figure; The next step is the same movements, but already horizontally.

Then it will remain:

reveal all the resulting bends;
Raise the lowest origami point to the center;
take the vertex to the base of the composition;
Swap triangular valves - upper and lower;
Right edge folded towards the center;
Left edge too folded towards the center;
turn over the workpiece;
bend the upper corners on the left and right;
bend exactly the lower corners, turn the blank on the front side;
Bend the bottom edge of the figure;
Return the top to the former place, seeking now everything is divided into 3 of the same site;
omit the top again to create a third "tooth";
Divide the side corners to the sides, creating "eyes";
From the inside to bring origami, giving it volume;
Partially deploy lower corners, seeking stability of the figure.

Creating ghosts

Crafts in the form of terrible ghosts also completely harmoniously fit into the concept of an old holiday. And they are much easier to make them than usually thinking people. Such figures are quite accessible even for children. All you need to gradually create a phantom - white paper and black marker or felt-tip pen. Start with the preparation of diagonal folds.

Further according to the scheme:

deploying the square, bend the side triangles to the middle;
Carefully paint the figure on the right;
Create an external tab of the triangular form;
add the same tab on the left;
turn over origami and narrow the lower part, flexing the sidewalls to the midline;
turn over the workpiece with the other side;
The previously obtained corners are bred to the sides, and the top is bend back;
Film in the lower part of the ghost;
Dorisy the eyes and mouth of phantom (their expression is determined at their discretion).

Production of volatile mouse

This origami is obtained by turning primarily a square sheet of paper into a triangle. Next, it is necessary to fold the base of the resulting triangle. "Wings" were formed - but so far they are early to paint, and it is necessary to fold to the middle. Only then comes the time to reveal the wings and adjust them a little.

The final stages of the work are the trimming of the top of the figure, so that something like the characteristic ears, and the drawing by watercolor paints of expression on the face of the bats.

Other ideas

Quite just make as well spider . Its base can be of any color on the choice of creators, but still logical to make a black or gray creature. Folding the sheet twice, fuse it diagonally. When the same thing was done with three other faces, it should be rhombus. His corners are folded and lay out several times, seeking clear folds.

Further:

Apply the reception of the origami "petal" 4 times;
cut the resulting legs in half (as the spider has 8 legs);
fold sash left to right;
rotate the resulting form by 180 degrees;
flex one of the corners down;
Flags pacues on the sides;
Take the eye.

Another characteristic Halloween attribute is Witify hat . For it, black paper of large format is used. Leaf 10x10 cm is folded diagonally in two different directions (in turn). Expanding the workpiece, sweep the bottom angle to its center. Next, the bottom rebels toward the center.

Later:

turn over and flex a craft for the already formed bending;
sweep to the middle line right and left corners;
Right and left lower edges upstairs.

Not bad idea will also make claws on Halloween. Having laid out a sheet of paper on a flat surface, weigh the upper right angle to the left lower, but do not bring to the end. The left side is shifted to the opposite corner. In the resulting incomplete rectangle, the top is removed down.