In the process of creating a manicure, sometimes it happens that the lacquer is spilled, and its drops fall on the surrounding surfaces, including the carpet. The situation is unpleasant, but it can be corrected using various means for cleaning.
Fresh spots
If the carpet is dear, and the stain is large, it is better not to risk and contact dry cleaning. But the carpet can be big, or it is impossible to remove, without moving heavy furniture. In this case, you will have to act. Remove nail polish with carpet easier if the stain is fresh. If the varnish shed a lot, then you will first need to remove its excess with a metal or plastic flat item. For this purpose, you can use a conventional spoon. Only it needs to be thoroughly cleaned from varnish before each touch to the carpet to prevent increase size of the spot.
Honey is not worth it, since the pile of carpet begins to actively absorb shedding drops. In addition, some types of varnishes are pretty quickly thick.
To remove the remaining stain, use a means that dissolves well. Usually, traditional varnish removal fluids are perfectly coping with this task. More sparing is liquid without acetone, but it does not always turn out to be effective. In modern lacquer removal fluids, additives change the color of the composition often contain, and it can be quite saturated. Colored liquids for light carpets should not be applied. The best results will give acetone, but it can be too aggressive both to the painting and the very pile of carpet.
In any case, regardless of the fund used, you need to test on the lowest floor of the floor covering.
If the test did not reveal problems, the tool is applied to a clean cloth or a piece of watts and torn the blurred vault gently. Spanish the place is not worth not to increase its area. The process is quite long, especially if bright lacquer left the trail on the bright carpet. Pour tool on the carpet should not: This will contribute to the expansion of the area of pollution. In addition, the liquid may cause damage to the carpet. To make it easier for work, it is recommended to periodically make a stain with water: it will not give contamination to dry. You can finish cleaning with a soap solution or a special carpet cleaning agent.
For white carpets, you can use hydrogen peroxide. It is mixed with water in proportion 1/1 and wetted with the resulting solution to the cleaned area. Then the carpet needs to dry and flush the pile. It should be known that hydrogen peroxide cannot be used for colored carpets due to the whitening effect effect. Dark carpet can try to clean with hair varnish. It needs to be sprayed on a stain, pre-richly moistened with water, and wait for a 0.5-1 minute, and then wipe the patches with a napkin. You can also apply alcohol on your cotton disk and erase the stain.
As the napkins are contaminated and the discs should be replaced with clean.
Old traces
Soased spots will require a little more effort. However, in this case, there are quite effective ways. On some types of materials, varnish can be simply scraped with villi. If the varnish is not very deeply absorbed, and the pile of coating is long and thick, then you can try to cut pollution carefully. With a large spot, this should not be done: it will be very noticeable.
An old stain can also be erased using a varnish fluid. To her, if there is at hand, add alcohol. On abundantly moistened with water, the polluted area is applied to the removal of varnish (can with alcohol) in small quantities. After some time, the varnish begins to break down, and it must be accurately removed with a thick brush. For this purpose, an old toothbrush will fit. Bristles brushes should not slide on the surface of the spots. Sleeping the varnish should be movement from below, from the base of the carpet, up. The brush should be cleaned after each contact with the carpet.
Conducted manipulations do not always allow you to fully cope with the problem. Finally, acetone or peeled gasoline will help finally laundering. Before using them, you need to test the test: they can wash off the paint from the carpet. It should be noted that the cleaning procedure should be carried out with a good influx of fresh air, since a long-term inhalation of steam of acetone-containing liquids cannot be considered useful.
You can try to remove the stain using special cleaning products, the wide range of which is offered in business stores. However, you need to carefully read about their purpose and properties. This information is usually contained on the package.
When using these chemicals, it is necessary to strictly follow the instructions.
From the primary means you can try to use the wiper. Liquids for cleaning glass, as a rule, are neutral to the carpet color and do not damage it. The tool is applied to pollution and leave for 2-3 minutes. Then the stain must be lined with a cloth or cotton swab. Complete the procedure needed with cool water, which is wetted with a clean rag.
About how to remove the lacquer from the carpet, look in the video below.